Marketplace - Household, garden

Pool pump as good as new with warranty !,original packaging

Published: 02.09.2024
Visits: 789
Original German. This ad has been automatically translated.

Pool pump as good as new with warranty !,original packaging

Offer here a swimming pool pump Jardino Pool Nox 25 6M with guarantee and invoice, as good as new due to move. Price VB 150€
Power: 0.25 HP single phase
Manufacturer: ESPA
Product Code: 203180
Compact and robust design
Suction and discharge nozzles for pipes with a diameter of 38 mm.
Ideal for above-ground and above-ground swimming pools
Compatible with chlorinated water or salt water (max. 7gr/l)
Compact and robust design
Warranty: 3 years

Features

MATERIALS

Motor Housing: Aluminum
Mechanical Seal: Alumina-Graphite
Intake Housing: Technopolymer
Sheathing: Technopolymer
Blow-out housing: Technopolymer
Diffuser: Technopolymer
Drive shaft: AISI-431 stainless steel
Impeller: Technopolymer
Seals: NBR/EPDM
Pre-filter: Technopolymer
LIMITS

Maximum Liquid Temperature: 40ºC
Compatible with chlorinated water and salt water (up to 7 grams/litre).

DESIGN FEATURES

Inlet diameter: 40 mm
Outlet diameter: 40 mm
Sealing by mechanical seal
Suction Connection Type: Hose Connection
Type of supply connection: Hose connection
ELECTRICAL PROPERTIES

Electrical Insulation: Class F
Operating Factor: S1
Degree of protection: IPX5
Default: automatic
Motor Type: Asynchronous
Commissioning

PRELIMINARY EXAMINATIONS

1. Check that the mains voltage and frequency match the voltage and frequency indicated on the nameplate.

2. Make sure the pump shaft can rotate freely.

3. Completely fill the pump housing with water by unscrewing the cover of the pre-filter. Make sure there are no leaking gaskets or fittings.

4. Put the pre-filter lid back on and screw it in place properly.

THE PUMP MUST NEVER RUN DRY.

COMMISSIONING

1. Open all shut-off valves in the piping, both in the suction and pressure areas.

2. Turn on the power switch. It may take a few seconds for the water to flow through the entire length of the pipe.

3. Check the direction of rotation of the motor, which should be clockwise from the fan. With three-phase pumps, there is a possibility that the motor will rotate in the opposite direction, so the flow will be lower than expected. In this case, you need to reverse the two phases of the power supply in the terminal board.

4. Check whether the current consumed is equal to or less than the maximum current indicated on the nameplate. If necessary, readjust the thermal relay.

5. If the engine does not work or does not suck in water, try to identify the anomaly using the list of the most common possible failures and their possible solutions on the following pages.

MAINTENANCE

The swimming pool pumps do not require any special maintenance, but it is recommended to clean the pump filter regularly and drain the pump body via the drain plug during periods of low temperatures.

In case of prolonged inactivity, it is advisable to drain the pump, clean it and replace the filter cover with petroleum jelly on the rubber seal, taking care to keep the room where the pump is stored dry and ventilated.

In the event of a malfunction, the user must not tamper with the pump. Contact an authorized service center.

Dimensions and weight

Guarantee

The warranty period is 3 years from the date of the purchase invoice of the product.

The standard warranty excludes all components that are subject to wear and tear on the pump during normal use, such as:

- Mechanical seal
-Seals
-Condenser
-Bearing
- Pre-filter basket

In the event of a defect, the pump must not be handled and an authorized service center must be contacted.


Show all classified ads of the user (4) Contact Advertiser Add to watchlist Back
Share the ad